AUS Pro86 Mix Euro Bedienungsanleitung Seite 13

4. Take one banknote and check the lower boundary of the slot.
For this, one banknote should freely pass between the upper feed rollers (Figure C, posi-
tion 1) and the lower feed rollers (Figure C) position 3). If one banknote cannot pass
through between the upper and lower feed rollers, increase the slot by 2-5 degrees (1/10
division) and check again.
5. Take one banknote and check the upper boundary of the slot. For this, two banknotes
SHALL NOT PASS THROUGH between the upper and the lower feeder rollers
(Figure C). If two banknotes pass through between the upper and lower feed rollers,
reduce the slot by 2-5 degrees (1/10 division) and then check again.
6. If the slot's lower and upper boundaries are set correctly in accordance with para-
graphs 5, the slot is set correctly.
Figure C
Symbols:
1 Upper feed roller
2 Kicker roller
3 Lower feed roller
4 Slot (between the upper and lower feed rollers)
13