Adjustment Of The Slot Size And Its Correct Setting - AUS Pro86 Mix Euro Bedienungsanleitung

12

Adjustment of the slot size and its correct setting

12.1 It is important to remember, that different currencies, depending on the thickness
of the banknotes, require correct adjustment of the slot (Figure C, position 4) between
the upper and lower feed rollers. Adjusting the feeder slot size is possible by using the
paper thickness adjustment screw (Fig. 1-5). Turn the screw counterclockwise to
decrease the feeder slot size and clockwise to increase the size. Adjusting the feeder
slot size shall be done smoothly, with adjustments of no more than 2-5 degrees (1/10
division). The feeder slot shall be larger for excessively worn banknotes, dirty ban-
knotes and USD. The feeder slot shall be smaller for "new" banknotes and EURO ban-
knotes.
- If due to adjustment of the feeder slot size the sensor starts to operate abnormally
slowly, and/or indicates «CF2», «CF3», or «EH» errors, then the slot size shall be
smoothly increased.
- If due to adjustment of the feeder slot size the sensor starts to indicate «EC» or «Ed»
errors, then the slot size shall be smoothly decreased.
12.2 To check whether the setting of the feeder slot is correct, take the following actions:
1. Turn off the power.
2. Prepare two banknotes (in medium usage condition or nearly new).
3. To properly set up the kicker rollers (Figure B, position 2) and feed rollers as shown
in Figure B (a smooth side facing you, with ribbed lining out of sight), turn the kicker
rollers(Figure B, position 2) so that they take the position as shown in figure B.
Figure B
Figure A
12