AUS Pro86 Mix Euro Bedienungsanleitung Seite 15

Code Message
1 A half banknote has been
detected
EH 2 A banknote passes through
incorrectly
1. The currency being counted is
other than EURO
CF-2
2. . Error of magnetic thread
detection MT, MG
3. Counted banknotes of mixed
denominations in «SORT» mode
4. The magnetic thread detection
level does not correspond to the
banknote
CF-3
5. Incorrect placement banknotes in
the counter
6. Improperly adjusted slot.
7. Two EURO banknotes stuck
together
Reason
1. Remove the banknote (lying on the top). Press
the «START» button and repeat the counting
procedure.
2. Count banknotes once again. Banknotes shall be
placed in a neat stack on the hopper. You must
align banknotes in a neat stack without distortion
(Figure 1, position 4)
1. «VALUE» and «SORT» modes are only for
EURO banknotes counting
2. Remove the banknote (lying on the top) and
verify it with IR detector
3. «SORT» mode is used only for counting
banknotes of the same denomination
4. Remove the banknote (lying on the top) and
verify it with IR detector
5. Put banknotes into the hopper. Banknotes shall
be placed in a neat stack on the hopper. You must
align banknotes in a neat stack without distortion
(see cl. 9.1)
6. Adjust the slot under cl. 12
7. Decrease the slot under cl. 12
15