Safety Instructions - Klarstein 10030509 Anschluss- Und Anwendungshinweise

Product safety
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali-
fied persons in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or in-
struction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instruction.
• Use two or more people to move and install appliance. Failure to do so can result in back or other injury.
• To ensure proper ventilation for your appliance, the front and the back of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 16 and below 32°C. This unit must
be installed in an area protected from the element, such as wind, rain, water spray or drips. Failure to do
so can result in fire.
• The appliance should not be located next to ovens, grills or other sources of high heat.
• The appliance must be installed with all electrical, water and drain connections in accordance with state
and local codes. A standard electrical supply (220 V AC only 60 Hz), properly grounded in accordance with
local codes and ordinances is required.
• Do not kink or pinch the power supply cord of appliance.
• The fuse (or circuit breaker) size should be 2.5 amperes.
Placement
• There should be left at least 200 cm³ for ventilation.
• The distance between wall and refrigerator side should be at least 20mm.
• The bottom should be left at least 50mm for air flowing air passing through must not be preheated.
• Entire cooling system should be considered in the ventilation.
• The following four pictures show four installation ways:
• This refrigerator is designed to be free standing installation only, and should not be recessed or built-in
• (Fully recessed). Allow 13cm of space between the back and sides of the refrigerator, which allows the
proper air circulation to cool the heat sink.
• Failure to do so can possibly cause the fire.
• Place your refrigerator on a surface that is strong enough to support it when it is fully loaded.
• Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the unit not to perform properly.
• This refrigerator uses thermoelectric refrigeration technology (no compressor) and is not designed for stor-
age in hot areas like garages, warehouses or outdoors since it is designed to operate at a maximum of 17
below the ambient temperature.
• Avoid locating the unit in moist areas.

Safety Instructions

10