Oase ProMax Pressure Automatic 5500/5 Gebrauchsanleitung Seite 16

Vertical installation of the pump with
the stand
(Only ProMax Pressure
5500/5, 6000/8)
The pump can be vertically installed with
the stand in a tank or well.
• Ensure that the screen on the suction
side is at least 150 mm below the sur-
face of the water.
• If the water contains sand and/or is
soiled, install the pump in a raised posi-
tion or use ProMax Floating Intake
(57772).
How to proceed:
 D
1. Push the mounting feet onto the stand.
2. Undo the Allen screws until the opening
of the stand is wide enough to fit onto
the pump.
3. Push the pump into the stand.
4. Tighten the Allen screws until the pump
is fixed in the stand.
16 ProMax Pressure Automatic 5500/5, 6000/8, Well Automatic 6000/8
Horizontal installation of the pump
with the stand
Automatic (Only
5500/5, 6000/8)
The pump can be horizontally installed
with the stand in a shallow tank or well.
• The pump has to be aligned exactly hor-
izontally.
• Ensure that the water to be pumped
does not contain any sand.
How to proceed:
 E
1. Remove the Allen screws.
– The stand consists of two sections.
2. Push two mounting feet onto each stand
section.
3. Push three rubber pads each into the
grooves of the opening of the stand sec-
tions.
– Fit rubber pads to both stand sec-
tions.
4. Push both stand sections onto the
pump.
– The stand sections should be spaced
as far apart as possible to ensure the
stability of the pump.
ProMax Pressure Automatic