Cleaning The Surface Of The Device; Cleaning The Accessories - Pacojet Junior Bedienungsanleitung

2
1
Rinsing cycle
Rinse the device as described in Chapter "8.1.4 Rinsing cycle" on page 25.
8.1.6

Cleaning the surface of the device

The device's cladding and base can be wiped down with a non-fuzzing cloth and commercially
available cleaning agent.
8.1.7

Cleaning the accessories

The components included in the following list can be cleaned in a dishwasher:
• Spray guard (8)
• Pacotizing blade (9)
• Pacotizing beaker (10)
• Protective beaker (12)
• Rinsing insert, green (13)
• Blue sealing ring (14)
• Cleaning insert, blue (15)
5.
Press the START KEY (21). The cleaning cycle starts.
Remember that the device needs to be in "operating
mode" for this (see "START KEY" on page 13).
6.
During the cleaning cycle, you can press
the depressurization button (7) to rinse the
depressurization hose. To do this, press the
depressurization button while the pacotizing shaft (2)
is moving up 1 . Make sure that you hold a container
at the end of the depressurization hose in order to
catch the water that sprays out
7.
At the end of the rinsing cycle (the motor stops),
remove the protective beaker (12) with the pacotizing
beaker (10).
To do this, turn the protective beaker approximately
90° to the right and slide it out at the bottom
Remove the blue cleaning insert (15) and the blue
sealing ring (14)
.
2
2 . Empty the pacotizing beaker.
EN
1 .
29