Operation - Chauvet DJ Funfetti Shot Anleitung

Funfetti Shot QRG

Operation

Control from the
Display
FC-W Wireless
Remote Control
1. Fill the main tube with Funfetti Shot refills (FRC, FRM, and FRU, sold
separately).
Note: The use of CHAUVET Funfetti Shot refills, specially
manufactured for use with Funfetti Shot launchers, is
recommended. The standard tank capacity is: 0.5 lb (0.25 kg) for
FRC and FRU;
1 lb (0.45 kg) for FRM.
2. Plug into a suitable power outlet.
3. Turn on the Funfetti Shot by one of the following:
·
Pressing the <MENU> and <ENTER> buttons at the same time.
·
Using DMX activation.
·
Pressing the button assigned to CH-1 on the FC-W wireless remote
control.
Note: To refill the Funfetti Shot launcher, turn off the launcher and
add more Funfetti Shot refills to the main tube.
Press the <MENU> and <ENTER> buttons at the same time. This will
activate the Funfetti Shot blower fan immediately. Press buttons again to shut
off.
·
The display will show d 1 while in this standalone mode.
·
Set your DMX before loading Funfetti Shot refills.
·
The fan will blast confetti up to 30 ft (9 m) and run for 25 seconds.
To trigger the Funfetti Shot using the FC-W wireless remote control, plug in
the product and do the following:
1. Plug the wireless receiver into the Wireless Remote port on the side of the
Funfetti Shot.
2. On the wireless transmitter, press the button assigned to CH-1 (1–4) and
the Funfetti Shot fan turns on.
For more information on the FC-W or to download instructions, go to
http://www.chauvetlighting.com.
6
EN