Hama Premium Bedienungsanleitung Seite 24

8. Continual video loop settings:
To use the continual video loop function, some settings
on the picture frame have to be adjusted.
First, confi gure the Setup menu so that the picture
frame begins showing videos when it is turned on
(Setup -> Start mode -> Film).
You also need to adjust the settings so that the directory
is repeated for videos. To do so, play a video and then
press the Enter key on the remote control. A function
bar will then appear on the screen.
On the far right, you now have the option of choosing
between the following modes:
To set the continual video loop, press the arrow button
(>) on the remote control 10 times, until the folder mode
appears. Now you can select the desired repeat func-
tion with the Enter button.
• Standard (does not repeat)
• Repeat one track (the current video is continually
repeated)
• Repeat folder (all videos in the directory are repeated
one after the other, and the whole directory is then
repeated afterwards).
Caution:
This function is only supported for fi rmware version
HA08V1.9-10-4-IN-SP-BT and higher.
9. Bluetooth:
Confi guring the Bluetooth function of the
digital picture frame
1.) Activate the Bluetooth function of the digital picture
frame as follows:
• Main menu -> Setup -> Factory settings -> Bluetooth
on/off -> ON
The Bluetooth function of the digital picture frame is
now activated. Ensure that the
Nano Bluetooth dongle is attached to the USB port!
2.) Activate the Bluetooth-enabled device (mobile
phone, PC, etc.) which you intend to use.
Confi gure/activate the Bluetooth mode according to
the operating instructions of the device.
3.) Have your device search for existing Bluetooth
connections. The digital picture frame is detected as
either "Digi Frame" or "Amlogic".
4.) Enter "0000" when prompted to enter the PIN.
5.) As soon as the display indicates that a connection
has been established properly, you can begin to
transfer data via the Bluetooth connection to the
internal memory of the digital picture frame. You may
also have to follow other instructions of the transfer
device (e.g. mobile phones or PCs) (see the
instructions of the transfer device).
Note:
Note that not all Bluetooth devices are compatible
with one another (depends on profi les and internal
passwords).
Caution:
To connect USB devices to the digital picture frame
with a standard type-A USB connector, carefully pull
the Bluetooth dongle out of the USB port. In this case,
please keep the Bluetooth dongle in a safe place
so that you do not lose it.
The enclosed Bluetooth dongle is available separately
under Hama item no.: - 49227: "Nano Bluetooth
dongle". The current driver for the dongle can be
downloaded from the Hama Internet site (www.hama.de/
www.hama.com). It allows you to install the enclosed
Nano Bluetooth dongle on other devices (e.g. on a PC,
laptop, etc.) to enable Bluetooth support.
Confi guring the Bluetooth connection via a PC/laptop
Please follow steps 1.) to 5.) mentioned above to
establish the Bluetooth connection between your
PC/laptop.
6.) Now select the photo/fi le to be transferred and begin
transfer (see next example).
23