Operation; Switching On The Cleaning Module; Starting The Cleaning Process; Switching Off The Cleaning Module In An Emergency - ECOLAB DM Modular 20 Kurz- Betriebsanleitung

Operation

5 Operation
5.1

Switching on the Cleaning Module

Before switching on the unit, familiarise yourself with how to use the unit by reading these
operating instructions carefully.
On switching on the unit, the unit type and software version will be briefly displayed.
Then the unit will go into the operating mode saved when it was last switched off.
5.2

Starting the cleaning process

The complete description can be found in the relevant chapter of the operating
instructions (417102257).
5.3

Switching off the Cleaning Module in an emergency

CAUTION!
In an emergency, disconnect the mains plug from the power supply and secure
it against being switched back on again. We recommend unplugging the power
cable (IEC connector) at the rear of the unit and keeping it safe.
Should fault alerts occur, read the chapter entitled "Troubleshooting" in the
operating instructions (417102257) thoroughly.
5.4

Changing the product container

The complete description can be found in the relevant chapter of the operating
instructions (417102257).
5.5

Maintenance work during operation

The complete description can be found in the relevant chapter of the operating
instructions (417102257).
Version 01-06.2018 14