Black & Decker GD300 Handbuch Seite 5

the appliance when any guard or enclosure is damaged
or not in place. Do not use the appliance if any part is
damaged or defective. Do not use the appliance if the
switch does not turn it on and off. Have any damaged or
defective parts repaired or replaced by an authorised
repair agent.
Check the cable frequently for damage. If the cable is
damaged, it must be replaced by an authorised repair
agent in order to prevent a hazard. Inspect extension
cables periodically. Replace a damaged extension
cable immediately.
Keep all nuts, bolts and screws on the appliance tight to
ensure a safe working condition.
Check the grass box for wear or damage and replace it
if necessary. Never use the appliance without the grass
box.
When not in use, the appliance should be stored in a dry
place. Children should not have access to stored
appliances.
Ensure that only replacement cutting means of the right
type are used.
Use only Black & Decker recommended spare parts and
accessories.
Warning symbols
The following warning symbols are found on the appliance:
Read the manual prior to operation.
Do not expose the appliance to rain or high
humidity.
Keep bystanders away.
Beware of the sharp tines. Tines continue to rotate
after the motor is switched off - remove plug from
mains before maintenance or if the cord is
damaged.
Keep the cable away from the cutting tines.
The tines will continue to rotate after the machine
is switched off.
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard
Electric safety can be further improved by using a high-
sensitivity 30 mA residual current device (RCD).
Extension cables & class 1 product
A 3 core cable must be used as your tool is earthed and
of class 1 construction.
Up to 30m (100 ft) can be used without loss of power.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
1. Grass box
2. Motor cover
3. Switch box
4. Lock-off button
5. Switch lever
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Assembling the upper handle (fig. A)
Make sure that the cable restraint loop is fitted to the
upper handle prior to assembly.
Fit the lower handle part (7) to the upper handle (6)
using the knobs (10), washers (9) and screws (8)
as shown.
Fitting the lower handle (fig. C)
Insert the ends of the lower handle (7) into the
corresponding holes in the raker.
Press the handle down as far as it will go.
Secure the handle using the screws (12).
Fixing the cable (fig. B)
The motor cable has to be fixed using the cable restraints.
Clip the one restraint (11) onto the cable leading from
the switchbox (3) to the motor. Secure the restraint to
the lower handle (7).
Clip the other restraint (11) onto the cable leading from
the switchbox (3) to the motor plug. Secure the restraint
to the upper handle (7).
Warning! Make sure the cable is secured using the cable
restraints prior to connecting the plug to the mains outlet.
ENGLISH
5