Bosch GTR 30 CE Professional Originalbetriebsanleitung Seite 19

OBJ_BUCH-1209-004.book Page 19 Wednesday, March 2, 2011 2:00 PM
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
05.08.2010
Assembly
Before any work on the machine itself, pull
the mains plug.
Adjusting the Handle Strap
(see figure A)
Adjust the handle strap to the size of your
hand to ensure safe operating with the pow-
er tool.
– Open the Velcro fastener of the handle strap
2.
Bosch Power Tools
– Hold the machine with your hand and close
the short strap as required.
– Tension the long strap of the handle strap 2
and close the Velcro fastener.
Mounting the Adjustable Footplate
(see figure B)
For routing applications, the footplate 7 must be
mounted.
– Release the clamping lever 6.
– Bring the marks on the power tool and the
footplate 7 into alignment as shown in the
figure.
– Push the footplate 7 to the stop and close
the clamping lever 6.
Replacing the Collet (see figure C)
Depending on the routing tool being used, the
collet 13 may need to be replaced before insert-
ing the router bit.
When the right collet for your router bit is al-
ready mounted, follow the work steps as de-
scribed under "Adjusting the Depth-of-cut".
The collet 13 must have somewhat play when
seated in the tightening nut. The tightening nut
3 must assemble easily. Should the tightening
nut or collet be damaged, replace immediately.
– Push the spindle lock button 15 and keep it
pressed. If required, rotate the motor spindle
by hand until it locks.
– Unscrew the union nut 3 with open-end span-
ner 1.
– Release the spindle lock button.
– If required, clean all parts to be mounted pri-
or to assembling, using a soft brush or by
blowing out with compressed air.
– Insert the union nut into the tool holder 14.
– Hand-tighten the tightening nut.
Do not tighten the tightening nut of the col-
let without a router bit inserted. Otherwise
the collet can be damaged.
English | 19
2 610 016 614 | (2.3.11)