Bosch GTR 30 CE Professional Originalbetriebsanleitung Seite 16

OBJ_BUCH-1209-004.book Page 16 Wednesday, March 2, 2011 2:00 PM
16 | English
g) If devices are provided for the connec-
tion of dust extraction and collection fa-
cilities, ensure these are connected and
properly used. Use of dust collection can
reduce dust-related hazards.
4) Power tool use and care
a) Do not force the power tool. Use the cor-
rect power tool for your application. The
correct power tool will do the job better
and safer at the rate for which it was de-
signed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the
switch is dangerous and must be re-
paired.
c) Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any adjust-
ments, changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfa-
miliar with the power tool or these in-
structions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tool's op-
eration. If damaged, have the power tool
repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Prop-
erly maintained cutting tools with sharp
cutting edges are less likely to bind and
are easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these in-
structions, taking into account the work-
ing conditions and the work to be per-
formed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
2 610 016 614 | (2.3.11)
5) Service
a) Have your power tool serviced by a qual-
ified repair person using only identical
replacement parts. This will ensure that
the safety of the power tool is maintained.
Safety Warnings for Routers
Hold power tool by insulated gripping sur-
faces, because the cutter may contact its
own cord. Cutting a "live" wire may make ex-
posed metal parts of the power tool "live"
and shock the operator.
Use clamps or another practical way to se-
cure and support the workpiece to a stable
platform. Holding the work by your hand or
against the body leaves it unstable and may
lead to loss of control.
The allowable speed of the router bit must
be at least as high as the maximum speed
listed on the power tool. Accessories that
rotate faster than permitted can be de-
stroyed.
Router bits or other accessories must fit ex-
actly in the tool holder (collet) of your ma-
chine. Routing bits that do not fit precisely in
the tool holder of the machine rotate irregu-
larly, vibrate heavily and can lead to loss of
control.
Apply the machine to the workpiece only
when switched on. Otherwise there is dan-
ger of kickback when the cutting tool jams in
the workpiece.
Keep your hands out of the routing area and
away from the router bit. Danger of injury.
Never cut over metal objects, nails or
screws. The router bit can become damaged
and lead to increased vibrations.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
Bosch Power Tools