Adjusting The Display Contrast - SubGear XP10 Bedienungsanleitung

Selecting 24 hours or AM/PM setting
Adjusting the date
Date (24h setting)
Day / Month / Year
Date (AM/PM setting)
Month / Day / Year

Adjusting the display contrast

Selecting the IrDA speed
Switching the sound on and off
If you turn off the sound, the buzzer is effectively deactivated. You will have no audible warnings
(alarms and attention messages)! Without audible warning you could get into potentially
hazardous situations, which could result in death or serious injury.
You must assume full responsibility for turning off the sound.
1. Confirm that you wish to change the setting by pushing
"On" or "off" starts to flash.
2. Switch with between "on" (AM/PM) and "off" (24h).
3. Confirm the setting with
The 24h - AM/PM setting influences the display of the date (see below).
1. Confirm that you wish to adjust the date by pushing
The first day (month) starts to flash.
2. Set the day (month) by pushing
3. Confirm the setting with
4. Set the month (day) by pushing
5. Confirm the setting with
6. Set the year by pushing
7. Confirm the setting with
1. Confirm that you wish to adjust the display contrast by pushing
The current setting starts to flash.
2. Set the contrast by pushing
Low contrast: (1), high contrast: (12)
3. Confirm the setting with
The default setting is low. For faster downloads you can set it to high, but
not all IrDA interfaces are compatible with high.
1. Confirm that you wish to change the IrDA speed by pushing
"Lo" (low) or "hi" (high) starts to flash.
2. Switch with between low and high.
3. Confirm the setting with
Low: 9600bits / second High: max 57 600bits / second
! WARNING
1. Confirm that you wish to change the setting by pushing
"off" starts to flash.
2. Switch with between "on" and "off".
3. Confirm the setting with
"000" appear.
.
or .
. The month (day) starts to flash.
or .
. The year starts to flash.
or .
.
or .
.
.
. If you have selected "off", "Code" and
Settings
.
.
.
.
. "On" or
35