Herunterladen Inhalt Inhalt Diese Seite drucken

Replacing The Battery (Battery Kit Includes Battery And Teflon Coated O-Ring) - SubGear XP10 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 41
2.1 Replacing the battery (Battery kit includes battery and Teflon coated o-ring)
Removing the battery clears all physiological data including saturation. This means that for
a repetitive dive the computer will not compute correctly. Diving after replacing the battery
when there is desaturation time left on the computer can lead to serious injury or death from
decompression sickness.
Change the battery only under these conditions:
• After a dive if you know you will not be diving, flying or going to higher altitude for the next
48 hours.
• Before a dive if there is no desaturation time left on the computer.
The change must be made with particular care in order to prevent water from seeping in. The
warranty does not cover damages due to an improper replacement of the battery.
Never touch the metal surface of the battery with bare fingers.
The two battery poles must never be short circuited.
Procedure:
To replace the battery you need a coin or a universal tool and a clean cloth.
! WARNING
• Avoid dropping or jarring your XP10.
• Do not allow your XP10 to be exposed to direct, intense sunlight.
• Rinse your XP10 thoroughly with fresh water after each dive.
• Do not store your XP10 in a sealed container; make sure there is free
ventilation.
• If there are problems with the water contacts, use soapy water to
clean XP10 and dry it thoroughly. The surface of your XP10 housing
can be treated with silicone grease. Do not apply grease to the water
contacts!
• Do not clean XP10 with liquids containing solvent (apart from water).
• Check the battery capacity before each dive ->15.
• If the battery icon appears, replace the battery ->37.
• Diving with a weak battery: XP10 may stop working during the dive,
service icon and error code "E3" or "E6" appear. Close the dive and
replace the battery ->37.
• On the surface: if service icon and error code "E3" appear, replace the
battery ->37.
All error codes other than E3: XP10 must not be used for any further
dives. Take your dive computer to an authorized SUBGEAR dealer.
! WARNING
! WARNING
Appendix
37

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis