Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Introduction
The HF500-Cotag is a compact Hands-Free reader for connection to SiPass Entro, Bewator 010 or DC800. The
HF500-Cotag is for indoor mounting. The reader is compatible with both active and passive Cotag cards and
tags. Hands-Free readers reads cards or tags without them being in contact with the reader.
The reader continuously transmits a low power radio frequency. When a card or tag is presented within the
field of the reader, it activates and transmits a unique identification number back to the reader. The reader
then sends this code to the connected control unit in SiPass Entro, Bewator 010 or DC800.
See Illustration
on page 9.
Mounting and Mechanical Installation
The reader can be mounted on all types of materials; it can be mounted behind glass or can even be flush
mounted.
The only limit is that the reader may not be completely surrounded by metal, if the reader is to be flush
mounted then the distance to surrounded metal should be at least 5 cm, no metal should be directly in front
of the reader.
When flush mounting the reader or mounting on metal the maximum read range would reduce.
Note! Avoid mounting the reader near sources of electrical noise, such as motors, generators, pumps,
computer installations and mains cabling.
The reader is supplied with its cover separate. If the cover has been fitted, remove it by pushing in the two
the lugs on its lower edge using a suitable screwdriver. Mark out the mounting holes, but don't mount the
reader until you have route the cable into the reader. Mount the reader at a height of 1 000 – 1 00 mm (from
the floor to the bottom edge of the reader).
Do not fit the cover to the reader until you have tested it. See Set-up below
All other information regarding installation and programming can be found in the manual supplied with the
control unit. Please refer to web site for information how to connect to older door controllers.
Connecting the HF500-Cotag to SiPass Entro door central DC22, DC12 - or DC800
Use a screened multicore cable (i.e. Belden 9536 6-core screen) for connection between the reader and the
door central. Maximum cable distance is 50 metres. Connect the cable screen in case of long distances or
disturbing environment, and then remove LK1 from the reader. See Illustration on page 9.
Note ! For SiPass Entro: connect to the Clock & Data terminal block. Set the link J4 in the door central to
+V = Vin.
D800:
For
Set jumper j1 to
The power to the door central will then also be fed to the reader.
ENGLISH
Vin
Clock & Data.
& jumper J4 to
Werbung
