First Aid; Packaging - Makita EBH253U Original Bedienungsanleitung

Never straighten or weld damaged cutting tools.
– Operate the Petrol Brushcutter with as little noise and contamination as
possible. In particular check the correct setting of the carburetor.
– Clean the Petrol Brushcutter at regular intervals and check that all screws
and nuts are well tightened.
– Never service or store the Petrol Brushcutter in the vicinity of naked flames.
– Always store the Petrol Brushcutter in locked rooms and with an emptied fuel
tank.
Observe the relevant accident prevention instructions issued by the relevant trade associations and by the insurance companies.
Do not perform any modifications on the Petrol Brushcutter as this will endanger your safety.
The performance of maintenance or repair work by the user is limited to those activities as described in the instruction manual. All other work is
to be done by an Authorized Service Agent. Use only genuine spare parts and accessories released and supplied by MAKITA.
Use of non-approved accessories and tools means increased risk of accidents.
MAKITA will not accept any liability for accidents or damage caused by the use of non-approved cutting tools and fixing devices of cutting tools,
or accessories.

First Aid

In case of accident make sure that a first-aid box is available in the vicinity of
the cutting operations. Immediately replace any item taken from the first aid box.
When asking for help, please give the following
information:
– Place of accident
– What happened
– Number of injured persons
– Kind of injuries
– Your name

Packaging

The MAKITA Petrol Brushcutter will be delivered in two protective cardboard
boxes to prevent transport damage. Cardboard is a basic raw material and
is therefore consequently reusable or suitable for recycling (waste paper
recycling).
Petrol Brushcutter: model EBH252U, EBH253U, EBH252L, EBH253L
(See TECHNICAL DATA for the specifications)
We declare under our sole responsibility that this product is in compliance with the following Directives, 2000/14/EC, 2006/42/EC.
The most important standards applied to properly meet the requirements of the above Directives were: EN11806.
Measured Sound Power: 109.3 dB (A)
Guarantee Sound Power: 111 dB (A)
These sound power levels wear measured in accordance with Council Directive, 2000/14/EC.
Conformity assessment procedure: Annex V.
Responsible Manufacturer:
Makita Corporation.
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton kyenes, Bucks MK15 8JD, ENGLAND
EC-DECLARATION OF CONFORMITY
19. DEC. 2008
Tomoyasu Kato
Director