Philips RQ12XX-series Bedienungsanleitung Seite 117

1 Hold the shaver upside down above the holder with the back of the
shaver pointing towards the holder.
2 Place the shaver body in the holder behind the two clips (1) and
press it down until it locks into place (2).
The display shows that the shaver is charging (see chapter 'The
,
display').
3 Press the on/off button on the Jet Clean System to start the cleaning
program.
The shaver display stops showing the charging indication.
,
, The cleaning light starts to flash and the shaver is automatically
lowered into the cleaning fluid.
The cleaning light flashes throughout the cleaning program, which
,
takes a few minutes.
During the first phase of the cleaning program, the shaver
,
automatically switches on and off several times and moves up and
down.
During the second phase of the cleaning program, the shaver is
,
placed in the drying position, indicated by the flashing drying symbol.
This phase takes approx. 2 hours. The shaver stays in this position
until the end of the program.
After the cleaning program, the charging indication appears on the
,
shaver display (see chapter 'The display').
Note: If you press the on/off button of the Jet Clean System during the cleaning
program, the program aborts. In this case, the cleaning or drying light stops
flashing and the holder moves to the highest position.
ENGLISH
17