Charging The Battery - Trisa Master Vac Gebrauchsanweisung

Fixing the wall mounting unit
Use the enclosed screws to fix the wall mounting unit at a suitable
location near a 230V socket:
Slide the charging pin (11) into the wall mounting (7) as shown in the
diagram and turn by 90°. The charging pin will then be locked
in place.
Hold the wall-mounting (7) unit vertically against the wall at the
required location. IMPORTANT: the charging connector (12) unit
must be positioned at the top end of the wall mounting. Mark
the screw holes on the wall and drill them out. Insert the plugs
into the holes and use the enclosed screws to fix the wall
holder.

Charging the battery

Plug the mains adapter (10) into a 230 V socket.
Plug the rechargeable vacuum cleaner into the wall-mounting (7) unit
in such a way that the charging connector (12) unit connects with the
charging pin (11) on the cleaner.
Once the charge indicator lamp (4) lights up, it indicates that the
appliance is fitted correctly to the wall-mounting unit and will be
charged.
The normal charging period is to 10-12 hours.
The provision of over-charge protection will prevent damage to the
battery if for a longer period of time.
Using
Use without accessories
Use the ON-OFF switch (5) to control the cleaner.
Using the crevice tool (9)
This is useful for cleaning crevices, corners, folds and places that are
difficult to reach. Simply place the crevice tool into the suction
opening. Pull out to remove.
- 17 -