Specifications; Specific Safety Rules - Makita HM0830T Betriebsanleitung

ENGLISH
1. Switch trigger
2. Lock button
3. Side grip
4. Bit
5. Change ring

SPECIFICATIONS

Blows per minute
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............ Read instruction manual.
............. DOUBLE INSULATION
Intended use
The tool is intended for chiselling work in concrete, brick,
stone and asphalt as well as for driving and compacting
with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
4
Explanation of general view
6. Commutator
7. Insulating tip
8. Carbon brush
9. Screwdriver
10. Rear cover
Model
Net weight
Safety class

SPECIFIC SAFETY RULES

END201-2
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to ham-
mer safety rules. If you use this tool unsafely or incor-
rectly, you can suffer serious personal injury.
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handles supplied with the tool. Loss
of control can cause personal injury.
3. Hold tools by insulated gripping surfaces when
ENE045-1
performing an operation where the cutting tool
may contact hidden wiring or its own cord. Contact
with a "live" wire will make exposed metal parts of the
tool "live" and shock the operator.
4. Wear a hard hat (safety helmet), safety glasses
ENF002-1
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly recom-
mended that you wear a dust mask and thickly
padded gloves.
5. Be sure the bit is secured in place before opera-
tion.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high loca-
tions.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
11. Brush holder cap
12. Hex wrench
13. Hex bolts
14. Grease
HM0830T
-1
2,700 min
405 mm
4.5 kg
/II
GEB004-2