Audisse Netbox Kurzanleitung Seite 15

17. To enter the WEP or WPA key, characters are selected and entered using the Tuning
Control Rotary. The highlight scrolls through the available characters as well as the three
controls on the right. The character currently highlighted will be entered when you press
the Tuning Control Rotary. Do this as needed until the complete key has been entered.
Remember, WEP keys only use the numbers 0-9 and letters A-F. WPA keys are sensitive to
upper and lower case characters. You must enter the key exactly or the radio will not connect
to the network. The three controls on the right-hand side of the screen have special functions.
You can quickly access these by pressing the Info button and then use the Tuning Control
Rotary and Select button as needed:
select ' ' to erase a character just entered
select ' ' when the complete key has been entered
select ' ' to cancel an re-run the Network Wizard
A fter the final character of the WEP or WPA key has been entered, highlight the '
and press the Tuning Control Rotary. Then screen will show 'Connecting...' and then 'Setup
wizard completed'. Press the Tuning Control Rotary to exit setup wizard. The radio should
now be able to connect to the network.
18. Once you have connected your radio to the network (and therefore also to the Internet) it will
display the main menu. Press the Power button to put the radio in Standby mode.
It should then display the time as obtained from the Internet. If the time display is not correct
for any reason, it can easily be adjusted later. The clock display will switch off after about 30
seconds if the radio is running on batteries.
If you have followed the steps on the preceding pages successfully, your radio will have
onnected to your router, and then made a connection to the Internet and set its clock. If this
is the case, then you can try listening to radio stations via the Internet.
Note: The clock display in Standby mode is only maintained when the radio is powered from
the mains.
If you are powering the radio from batteries, then the clock display will be switched off after
about 30 seconds and the radio will shut down completely in order to minimize battery usage.
The clock will be set to the current time the next time that you switch on the radio, depending
upon the clock update settings.
Important note: In Standby mode the alarm function can only be used when the radio is
operated on AC power. In Standby mode on battery power the radio will turn off fully after 30
seconds (battery power save mode) and will not be turned on by the alarm function/settings.
14
Key:
Network settings
Please wait Please wait
Connecting. _
Connecting.
' symbol
Main menu
Internet radio
Spotify Connect
Music player
DAB radio
FM radio
16 / 02 / 2017
14:35