Audisse Netbox Kurzanleitung Seite 13

8. You will then need to set 'Keep network connected'. If you need to be able to remotely
control the radio even when it has been put into standby, rotate the Tuning Control Rotary
to highlight 'YES' to activate this function or 'NO' to deactivate this function. You can also
choose to keep the network connected by using the 'Keep network connected' option in the
network setting menu. In the standby mode display either the WiFi signal indicator is shown
with or without a cross through it according to the chosen network settings.
9. The display will then show a list of WiFi regional options for the network set up. Rotate the
Tuning Control Rotary to highlight the required region and then press the Tuning Control
Rotary to select it. Your radio will then scan for available WiFi networks.
10. The radio will enter the Network Settings Wizard and will display 'Scanning...'. After a short
while the display will show a list of the available WiFi networks.
11. You will first need to identify your network in the list of network names presented by the
Network Wizard. If no networks are found then you may have to get your wireless router
working (please see the instructions supplied with it) or you may be too far from the router.
When the radio finds your wireless network, it displays the Network Name (SSID) for the
wireless access point on the screen. This is a name that is allocated to the access point in
your router by the person who set up the network – for example: 'Jones family' or 'Paul's
network'. If the router supports WiFi Protected Setup, then '[WPS]' will be shown in front of
the SSID. It is possible, and in some locations highly likely, that your radio will find more than
one wireless network, in which case you should choose which one you need to connect to.
12. Rotate the Tuning Control Rotary to see the SSID for each wireless network that has been
found. If your network is shown proceed to step 14. If it is not shown then proceed to step
13. If you make a mistake at any point, use the Backward button to go back to the previous
screen.
13. I f your network is not found, it may be because the router is configured not to broadcast the
SSID. You should then use the Tuning Control Rotary to highlight and select the '[Manual
config]' option in order to enter the network details manually. This is described in 'Manual
Network Configuration". If your network name is being broadcast, and it was not found, then
try re-scanning press the Backward button), and if necessary try moving your radio to a
location closer to your access point/router.
12
Network settings
Keep network connected?
Wlan region
Europe
Australia
Network settings
Network wizard
Scanning...
SSID
Jones family
[WPS]Paul's network
Smith
[Rescan]
SSID
[WPS]Paul's network
Smith
[Rescan]
[Manual config]