Checking Calibration - Agatec PL5 Bedienungsanleitung

Metal studs or other metal surfaces: Use the magnet on the universal
adaptor.
Drywall track: The universal adaptor is designed to extend over a drywall
track or floor stud. This allows for fast plumb set-up when framing out a wall.
Tripod with 1/4": Use the threaded hole located on the bottom of the laser
to attach it to a camera tripod.
Tripod with 5/8": Use the threaded hole located on the bottom of the
universal adaptor to attach it to a construction tripod.
Wall: Use the keyhole slot located on the back of the universal adaptor to
attach to a wall using a drywall screw (at least 5 cm / 2" long).
Floor: Place the laser directly on the floor; or, to see the "down" plumb beam
spot, put the laser on the universal adaptor.
Using the universal adaptor
The universal adaptor has been designed to simplify use for the following
applications:
• Drywall track
The downward plumb beam will be on the outside edge of the track or stud.
The top track or top stud can then be positioned in the same manner to assure
it is plumb with the floor track or stud.
8
Setup
• Floor to ceiling plumbing
Plumb beam is visible through the universal mount. When rotating the upper
part of the mount, the plumb beam stays in place.
• Laying out angles
Marks on the base enable laying out angles every 15°, such as 30° and 45°.

Checking calibration

We recommend that you check the instrument's accuracy before initial use;
then periodically to ensure proper reference.
Checking the horizontal level beams:
9