Dometic ORIGO A100 Bedienungsanleitung Seite 16

Mounting the stove
➤ Place the stove according to fig. 4, page 3.
➤ Mark the drill holes.
Use the fastening holes in the hinge as a template.
➤ Pre-drill the holes into the countertop where marked.
➤ Fasten the stove by screwing flat head screws through each drill hole in
the hinge (fig. 5 2, page 4).
➤ Install the magnetic locker in the front of the cutout (fig. 4 1, page 3).
➤ Place a class B-1 fire extinguisher in reaching distance.
7.3 Connecting the stove electrically
(Dometic ORIGO C100 and C200 only)
WARNING!
!
The stove may only be connected by a qualified specialist.
The following information is intended for technicians who are
familiar with the guidelines and safety precautions to be applied.
Observe the following safety instructions for the electrical connections:
NOTICE! Risk of short circuit!
A
 Always use sockets which are grounded and secured by
residual current circuit breakers.
 If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Fasten the cables securely.
 Do not pull on the cables.
 Lay the cables so that they cannot be tripped over or damaged.
➤ Check the type plate on the right side of the stove to ensure that the volt-
age of the unit matches the voltage of the source.
➤ Connect the three conductors of the connection cable to the AC mains.
➤ Secure the cable with a clamp.
16
Dometic ORIGO
EN