X-lite X-902 Gebrauchsanleitung Seite 24

1.4 - Visor removal
Follow the instructions below for each side of the helmet to
remove the visor:
1.4.1 - Pull up the visor completely (see 1.1).
5
1.4.2 - Press the visor spring pin (Fig. 5) towards the inner part of
the helmet to unhook it and simultaneously slide forward the
visor (which is equipped with guides) till its complete separation
from the side mechanism (fig. 6).
1.4.3 - Repeat the procedure 1.4.2 on the other side of the hel-
met.
Warning !
pins of the visor.
Warning !
specific instructions.
1.5 - Applying the visor
The side mechanisms must be in full open position to apply the
visor to the helmet. Should this not be the case, follow the
instructions below with the helmet without visor:
A) Pull up the red opening button on the helmet chin guard. (see
1.1.1 - fig. 1)
Don't loosen the adjusting screws on the hooking
For visor and mechanism cleaning operations, see
6
- 22 -