Service Data; Installation - Zanussi ZOU30601 Benutzerinformation

Problem
The oven does not heat up.
The lamp does not operate.
Steam and condensation settle
on the food and in the cavity of
the oven.

Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

WARNING!
Refer to Safety chapters.
Building Under
CAUTION!
Only a qualified and competent
person must do the installation of
the appliance. If you do not contact
a qualified or competent person, the
guarantee becomes invalid if there is
damage.
Before you install the appliance, fit it with the
applicable hob from the table.
Type
ZEV 6040
ZEV 6041
ZEV 6046
16
Possible cause
The fuse is released.
The lamp is defective.
You left the dish in the oven for
too long.
We recommend that you write the data here:
Maximum power
6000 W
6400 W
7600 W
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove
the rating plate from the appliance cavity.
.........................................
.........................................
.........................................
Electrical connection with the hob
The hob connection socket is at the top of the
oven cabinet. The hob has connection leads for
the cooking zones and the ground cable. The
leads have plug-in connectors. To connect the
hob to the oven, plug the connectors into the
correct oven sockets. The design of the plugs
and sockets prevents incorrect connections.
Remedy
www.zanussi.com