auna Kara Projectura Anschluss- Und Anwendungshinweise Seite 32

If your television does not have the required Video Input, you will need a RF modulator (Radio Frequen-
cy Modulator), which connects through your TV Antenna or cable line and serves as your Video Input .
The RF Modulator can be purchased at almost any consumer electronics retailer . If you are connecting
the video from the karaoke system to a television video input jack, you must specify the source the TV
is to display . Your TV tuser guide can tell you how to display the video signal from the 'Video In' jack .
If you do not have the manual for your TV, we suggest calling the TV manufacturer's customer service
department. Only the manufacturer will be able to tell you accurately how to configure your TV to dis-
play the video signal coming from the 'Video Input' jack .
Note: Some projection TV sets do not properly display the standard blue background used
on most CD+G discs. If the background colour is inconsistent or flashing, please try con-
necting your karaoke system to a standard CRT/LCD television instead.
Audio connection
Connect the unit to your TV or home stereo system using the White and Red connections on the sup-
plied patch cord . Plug the white end of the patch cord into the white AUDIO OUT jack on the unit . Plug
the red end of the patch cord into the red AUDIO OUT jack on unit . Now connect the other end of the
cable's white (left channel) and red (right channel) plugs to your TV or home stereo system's 'AUDIO
IN' or 'AUX IN' jacks.
Connecting a microphone
1 . Plug a microphone (one microphone is included) into the MIC 1 or MIC 2 JACK on the lower left side
of your unit. The mic output will be mixed with an audio source from CD/CD+G/USB flash drive.
2 . Slide ON/OFF switch on microphone to "ON" before singing and always slide to "OFF" after use .
Caution: Tapping or dropping the microphone while it is on can cause permanent damage
to it. Never grip and swing the microphone around by the connecting cord.
32