Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Original Instruction Manual
•
Do not use the tool if the power cord is damaged. Pull out the plug immediately of
the cord is damaged when working. Do not pull the power cord to disconnect the
plug f rom the mains socket. D amaged power c ords i ncrease the r isk o f el ectric
shock.
•
Avoid overheating the tool and workpiece- risk of material damage.
•
Do not touch accessories during or immediately after use – risk of burn injury.
•
Never clean hot tools with flammable agents – risk of fire and/or explosion.
•
Keep the handles clean, dry and free from oil and grease. Greasy handles make it
difficult to hold the tool – risk of personal injury and material damge.
•
In addition to these instructions, you should always comply with local regulations
and laws concerning health, safety and the environment.
•
Do not remove or cover symbols and marking on the product. Replace any stickers
that have become illegible or lost.
•
Only use the tool for dry sanding. There is an i ncreased risk of electric shock if
water enters a power tool.
TECHNICAL SPECIFICATIONS
Model
Voltage
Input current
No-load speed
Oscillation angle
Acoustic pressure level
Acoustic power level
Vibration
Limit of ambient conditions
NOISE/VIBRATION INFORMATION
Measured sound values determined according to EN 60745.
Wear hearing protection!
Vibration total values (triax vector sum) determined according to EN 60745:
The v ibration emission l evel g iven i n t his i nformation s heet has been measured i n
accordance with a standardised test given in EN 60745 and may be used to compare
one tool with another.
It may be used for a preliminary assessment of exposure.
The d eclared v ibration em ission l evel r epresents t he main a pplications o f t he tool.
However if the tool is used for different applications, with different accessories or poorly
maintained, the v ibration e mission may di ffer. T his may s ignificantly i ncrease t he
exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the
times when the tool is switched off or when it is running but not actually doing the job.
This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration
such as: maintain the tool and the accessories, keep the hands warm, organisation of
work patterns.
LIST OF MAIN PART
6
2303
230-240V ~ 50Hz
300 W
15000~23000 minˉ¹
3.0°
101,4 dB(A) k = 3 dB(A)
90,4 dB(A) k = 3 dB(A)
9,988 m/s²
k = 1,5 m/s²
10 - 40°C
En
01/2017
Werbung
Inhaltsverzeichnis
