Data-Logging; Usb - Consort C6010 Anleitung

1. Press MODE.
2. Select [MENU] and press OK.
3. Select [DATA] and press OK.
Start the data-logging:
1. Select [ACTIVATE] and press OK.
2. Decide whether data-logging should be carried out or not and press OK.
3. Select [CONTINUOUS] and press OK.
4. Decide whether the oldest data should be overwritten when the memory limit
is reached or not and press OK.
5. Select [INTERVAL] and press OK.
6. Select the desired time interval between the data-logging and press OK.
7. Return to the measurements by pressing MODE.
8. The data-logging starts according to the previous settings while the display
shows the logging-number e.g. [LOG.00027].
Process the stored values:
1. Select [PROCESS] and press OK.
2. Select [TABLE] or [SEND] to display or send the stored data and press OK to
con ti nue. Follow the in struc tions on the screen.
Erase the stored values:
1. Select [PROCESS] and press OK.
2. Select [ERASE] and press OK. Follow the in struc tions on the screen.
1. Press MODE.
2. Select [MENU] and press OK.
3. Select [USB] and press OK.
4. Select [INTERVAL] and press OK.
5. Select the desired in terval between the trans mitted data and press OK. Pre-set
to zero if no automatic transmit ting is re qui red.
6. Select [BAUD] and press OK.
7. Select the desired baud rate and press OK.
• You can download a suitable USB driver from www.consort.be.
1. Press MODE.
2. Select [MENU] and press OK.
3. Select [USER TABLES] and press OK.
4. Select [pH buffers] or [S/cm standards] and press OK.
5. Follow the in struc tions on the screen to enter the different values. The value
for 25°C is obligatory!
C6010 • C6020 • C6030 C6010 • C6020 • C6030 C6010 • C6020 • C6030 C6010 • C6020 • C6030

Data-logging

Data-logging

USB

User standard tables
8 8