Ion Measurement; Glp; Calibration Reminder - Consort C6010 Anleitung

Ion measurement

(C6030)

GLP

Calibration reminder

Calibration reminder
7
1. Select the desired mode by pressing MODE. The display will immediately show
the measured value according to the previous calibration. Should you want to
recalibrate, press CAL.
2. The instrument permits to choose between the possible standards (1, 10, 100
ng/l, 1, 10, 100 µg/l, 1, 10, 100 mg/l, 1, 10, 100 g/l). Select the proper values
and press OK. The unused standards should be switched off.
3. Select [CALIBRATE] and press OK.
4. After rinsing the electrodes with distilled water, immerse them in the first
standard solution. Select the first calibration value and press OK when read-
ings are stable. Go on in the same way with the next standard solutions.
5. Decide whether a blank correc tion should be carried out or not. Follow the
instruc tions on the screen. After rinsing the electro des with distilled water,
immerse them in a blank solution. When readings are stable press OK.
6. Rinse the electrodes with distilled water, immerse them in the samples, and
read the concentration on the display.
• Maintenance: we refer to the manual supplied with the ion specific elec-
trodes.
1. Select the desired range by pressing MODE and then press CAL.
2. Select [GLP] and press OK.
3. Select [SHOW REPORT] and press OK. Browse with é ê to show a complete
cali bration report.
Select [SEND REPORT] and press OK to send the report to a computer.
1. Select the desired range by pressing MODE and then press CAL.
2. Select [GLP] and press OK.
3. Select [INTERVAL] and press OK.
4. Select the desired time inter val be tween each automatic warning for a new
calibration of the elec trodes and press OK.
OK OK to send the report to a computer.
C6010 • C6020 • C6030 C6010 • C6020 • C6030