Wear Parts - Oase Varionaut 270 DMX/02 Gebrauchsanleitung

- EN -
Replacing the impeller unit
Note!
The impeller unit contains strong magnets that attract magnetic particles (e.g. iron filings).
 All particles must be removed from the impeller unit before reassembly. Any remaining particles can
cause irreparable damage to the impeller unit and motor block.
Prerequisite:
 The pipes at the inlet and outlet are removed.
How to proceed:
 I
1. Remove the screws for fastening the filter basket and remove the filter basket.
2. Remove the screws for fastening the stand and remove the stand.
3. Remove the four screws and take off the pump casing.
4. Pull out the impeller unit and replace if necessary.
– Use a wide-blade screwdriver to carefully lever out the impeller unit if necessary.
5. Fit the pump casing and and fasten with four screws.
6. Place the pump on the stand and fasten with the screws.
7. Fit the filter basket and screw tight.
Repair
Repair is not possible in the following cases. The pump has to be replaced.
 If there is no replacement part approved by OASE for a defective component.
 If an electric cable permanently connected to the pump becomes damaged.

Wear parts

The following components are wear parts and are excluded from the warranty:
 Impeller unit
 Bearing in the motor block
Storage/Over-wintering
The unit is frost-proof to -20 °C. If lower temperatures are expected, the unit must be removed and put into storage.
How to correctly store the unit:
 Thoroughly clean the unit, check it for damage and replace any damaged parts.
 Protect the DMX/RDM connectors from moisture and dirt.
 Do not immerse plugs in water.
Store the unit immersed in water or filled with water in a frost-free place.
Disposal
Note
Do not dispose of this unit with domestic waste.
 Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system provided
for this purpose.
24