Wear Parts; Spare Parts - Oase Filtral UVC 1500 Gebrauchsanleitung

- EN -
Prerequisite:
• Housing is opened. (→ Access to the device)
• The water housing of the UVC clarifier is opened.(→ Clean UVC clarifier)
How to proceed:
 M
1. Using a screwdriver, loosen the safety screw securing the union nut on the quartz glass.
2. Unscrew the union nut counter-clockwise, then carefully remove the quartz glass.
– Heavy impacts can damage the quartz glass or the UVC lamp underneath.
3. Carefully remove the lamp protection from the UVC lamp, then remove the shielding plate from the base and finally
pull the UVC lamp out of the base. Replace with a new UVC lamp.
– Only use UVC lamps that correspond with the device's technical data. (→ Technical data)
– After replacing the lamp, reinstall the shielding plate and the lamp protection at their respective positions.
4. Carefully slide the quartz glass with the union nut and the O-ring onto the UVC lamp.
– Pay attention that the O-ring is located between the union nut and the thread on the UVC clarifier, in order that
the quartz glass closes watertight.
5. Tighten the union nut in the clockwise direction as tightly as possible. Then tighten the safety screw on the union
nut.
6. Carefully slide the device head back onto the water housing.
– Pay attention that the big O-ring has been inserted so as to ensure that the housing is watertight.
7. Rotate the device head clockwise until the marking points to the closed lock.
8. Put the device back together by completely executing the steps in the reverse order.
Storage/overwintering
The unit is not frost-proof and has to be removed and put into storage if minus temperatures are expected.
How to correctly store the unit:
• Thoroughly clean the unit, check it for damage and replace any damaged parts.
• Drain the unit as far as possible, clean thoroughly and check for damage.
• Empty all hoses, pipes and connections as far as possible.
• Protect electrical connections from moisture and dirt.
• Store the pump submerged and in a frost-free environment.
• Protect open plug connections from moisture and dirt.

Wear parts

• Filter media
• Impeller unit
• UVC lamp, quartz glass and O ring for quartz glass

Spare parts

The use of original parts from OASE ensures continued
safe and reliable operation of the unit.
Please visit our website for spare parts drawings and spare
parts.
Disposal
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system
provided for this purpose.
• Dispose of UVC lamps by availing of the take-back system in place for this purpose.
22
www.oase-livingwater.com/spareparts