Configuration Mode - CARLO GAVAZZI WM20 Betriebsanleitung

Element Description
Intervention range with Filter s = 2
Measured value
Measurements displayed with Filter co = 2
Measurements displayed with Filter co = 10

Configuration mode

Configuration of the accessory modules and settings of the main unit parameters can be
performed before or after installation, but only when the icon
Parameters for the accessory modules can only be set when the modules are connected
to the main unit.
The parameters can be set in two ways:
• via the keypad of the main unit, see "Settings menu" on page 24
• using the UCS configuration software via the communication module with Modbus
protocol, see "Communication module overview" on page 62 or front optical port
via OptoProg (see relative documentation).
is displayed.
8021572 | WM20 | © 2016 | CARLO GAVAZZI Controls SpA
49