Maintenance; Fuse Protections; Troubleshooting Procedure - SLAT SON 24V 12A MS150 RACK Bedienungsanleitung

In order to ensure maximal and durable service, we strongly recommend that your product be maintained clean and
ensure that it is installed in a dry and ventilated location. We shall in no case be liable for damages associated with
improper use or incorrect maintenance of the equipment.
WARNING
Replacing the original battery with a battery of incorrect type may result in an explosion hazard.
Used batteries must be disposed of in compliance with recycling requirements.
F1 mother board (mains): rating
breaking capacity – size
F1 to F6 'amplifiers board' (6 outputs) :
rating - type – size
F1 to F3 'controlers' board (3 outputs):
rating - type – size
If the Power supply does not deliver voltage
•
Check mains presence on the mains terminal strip
•
Check the fuses
•
Check the voltage value on output terminals
•
The voltage on the battery cables must be identical to that of the load
•
Check that each 12 Vdc battery has a voltage greater than or equal to 11.5 Vdc
•
Repeat the measurement after having disconnected the load and the battery
•
Recheck the signalling of the indicator lights (see chapter 5)
•
If all the steps are validated, check the compatibility of your load
If the battery indicator light remains red
•
Check if the battery voltage is between 12Vdc and 30Vdc
•
Check the battery voltage polarity
If the battery does not take over after a mains fault
•
Check the voltage on the battery terminals
•
Check the battery fuse
•
Check the voltage on output terminals
If the indicator lights are not illuminated
•
Check mains presence on the mains terminal strip
•
Check the battery connection
•
Check that the wire ribbon is properly connected
•
Check the voltage on output terminals
For additional technical assistance, contact the SLAT hotline
or contact SLAT After-Sales Service to obtain an RMA (Return Material Authorisation) number.

6. Maintenance

7. Fuse protections

8. Troubleshooting procedure

+ 33 (0) 4 78 66 63 70
For return requests, visit our website
http://www.slat.fr/formulaireRMA.php
Returns are not accepted without an RMA number.
6.3 A Time lag for 24V version and 8A for 48V version
26
5x20
1500 A
32 A gG
10x38
5A F
5x20