Connection; Connection Diagram; Connection Specifications - SLAT SON 24V 12A MS150 RACK Bedienungsanleitung

2.2. Batteries
The battery temperature sensor must be placed as close to the battery as possible.
Battery wiring instructions
The power supply takes a resistance measurement of the battery mesh every 4 hours. The trigger threshold of the fault is
±10 %
13 mΩ in 24V and 26mΩ
power supply with its associated battery will not have the desired autonomy in the event of a mains outage.
To avoid initiating this fault, please note the following elements:
Use authorized batteries (see chapter 1.2.5).
-
Use battery cables that are as short and large as possible (35 mm² max).
-
For a cross-section of 10 mm², the resistance is 2 mΩ/m.
o
For a cross-section of 16 mm², the resistance is 1.25 mΩ/m.
o
For a cross-section of 25 mm², the resistance is 0.8 mΩ/m.
o
For a cross-section of 35 mm², the resistance is 0.6 mΩ/m.
o
Example: for battery cables (+ and -) 1.5 m in length and with a cross-section of 10 mm², the resistance is 6
mΩ.
Battery cables (+ and -) of 1.5 m in length and cross-section of 25 mm² allow correct operation with all the
recommended batteries.
Position the temperature sensor as close to the battery as possible.
-
The connections and crimping should be given special care.
-
A battery fuse adds 1 to 2 mΩ.
-
3.1.

Connection diagram

Important: the openings provided in the cabinet must be used. Do not create additional openings as doing so
may casue the device to malfunction and voids the warranty.
3.2.

Connection specifications

Mains: 2.5 mm².
-
Battery: 50 mm².
-
'Amplifiers' load (6 outputs): 16 mm².
-
'Controlers' load (3 outputs): 2.5 mm².
-
Alarm reports (plug-in): 1.5 mm².
-
±10%
in 48V. Exceeding this threshold is signalled by a battery fault and means that the

3. Connection

24