Lightmaxx Vega Halo 90 Bedienungsanleitung Seite 16

Installation:
Always check the device for damage before use. Use the original packaging or suitable transport or
storage packaging to protect the product optimally from infl uences such as dust or moisture, etc.
when not in use.
The device can be installed either standing or hanging. The mounting must always be done on a so-
lid support or an stable surface. Use the opening of the brackets to attach the device. Always create
a second, separate safeguard for the device, e.g. by means of a safety.
All work on the device (e.g. installation) should always be carried out on a stable and platform.
Make sure that the area below you is closed off.
Please note that the use of this device with a dimmer is not possible!
16
Note! (Operating conditions)
Due to its structural characteristics, the device is designed for indoor use. Do
not expose the device to rain, moisture or liquids, as this can cause damage.
Vibrations, dirt or sunlight can also lead to damage, avoid them!
Warning! (Power Supply)
Make sure that the device voltage matches your local mains voltage. It is
strongly recommended to protect your mains socket with a residual current
circuit breaker (RCD).
If you do not use your device for a longer period, disconnect the device from the
mains to minimize risks. The same applies to thunderstorms or fl oods, etc.
Warning! (Risk of injury from falling)
It must be ensured that the device complies with all legal standards and regula-
tions in the respective country of use. Ensure that the device is always secured
by a second mounting cable (e.g. Safety).
Warning! (Overheating)
The maximum permissible ambient temperature of this device is 40° C. Ensure
that the unit is always adequately ventilated.