Silvercrest KH 2398 Bedienungsanleitung Seite 44

2. Press the buttons UP
to set the date at day intervals. Pressing
and holding the buttons changes the date
at intervals of 10 days.
3. Press the button MODE/
again to save the date and to switch to
setting the memory function.
If you later press the DOWN button
automatic mode, the display o briefly shows
"DAY". Subsequently, the time and date dis-
play alternate themselves. To switch back to
an exclusive time display, press the button
DOWN l once again.

Setting the memory functions
You can programme in up to 6 dates, which
the appliance will remind you of when they
are reached.
1. In automatic mode press the button
MODE/ j three times. The display
o shows alternatively a date and the
SDA 1 indicator for reminder date 1.
2. Press the buttons UP
to set the first desired reminder date. As
the earliest possible date you can set the
following day. Pressing and holding one
of the buttons changes the display in ten-
minute intervals.
3. When you press the button TIMER g, the
year number is deactivated and thus you
are reminded on this date every year.
4. Should you wish to programme in further
SDA's, press the button MEM SCAN f to
select the desired memory positions 2-6.
The selected memory location (SDA 2-6)
will be indicated in the display o.
5. Follow the same steps with the other
dates.
6. To deactivate the memory function, pro-
gramme in a date that lies in the past.
7. Press the button MODE/
again to save the settings of the memory
function and to switch to setting the up-
date function.
/DOWN
 
1(/l
j once
l in

/DOWN
 
1(/l
j once
The appliance will remind you of a date
that you have set with the reminder function.
Then, on this given day from 08:00 – to
23:00, and on every full hour, the acoustic
reminder alarm sounds for 10 minutes if you
do not stop the alarm. In addition, the SDA-
panel in the display o blinks. To stop the
reminder alarm, press any button.
Setting the update function
Using this function, the appliance can auto-
matically update the settings for the clock
based on the RDS data.
1. In automatic mode press the button
MODE/
shows "UP DATE".
2. Press the button DOWN
vate the actualisation function. The blink-
ing clock symbol
disappears.
3. Press the button UP
update function. The hour symbol
pears.
4. Press the button MODE/
again to save the settings of the update
function (the display flashes for 15 sec-
onds, after that the saving is finalised)
and to switch to setting the 12 or 24 hour
mode.
Setting the dimmer function
In automatic mode press the button MODE
/ j five times. Or press and hold the
button DIMMER/AOT i to set the dimmer
function outside of the Settings menu. In the
display o appears either DIM ON (delivery
state) or DIM OFF. Press and hold the button
DIMMER/AOT i once again to change the
dimmer setting.
DIM ON: The display o lights up for 15 sec-
onds when a button is pressed.
DIM OFF: The display o is permanently lit.
- 42 -
j four times. The display o
l, to deacti-

in the display o then
1( to reactivate the

j once
ap-