Installation And Set-Up / Operation; Technical Information / Functioning / Parameters Adjustable Parameters - IFM Electronic efector 600 Bedienungsanleitung

Installation and set-up / operation

Check the safe functioning of the unit. The operation is maintenance-
free. Failure indication:
= too high a temperature
= too low a temperature
(flashing) = short-circuit in switching output 1/ 2;
the respective output is switched off.
Technical information / Functioning / Parameters
Adjustable parameters
Switch-on point
Upper limit value at which the output changes its switching sta-
tus.
Switch-off point
Lower limit value at which the output changes its switching
status.
rPx is always lower than SPx. The unit only accepts values which
are lower than SPx.
Changing the switch-on point also changes the switch-off point
(the hysteresis remains constant).
If the hysteresis is higher than the new switch point, it is
automatically reduced (rPx is set to the minimum setting value).
Setting ranges:
Configuration of the switching outputs
4 switching functions can be set:
22
°C -39.5 ... +125
°F -39 ... +257
Hno = hysteresis / normally open
Hnc = hysteresis / normally closed
Fno = window function / normally open
Fnc = window function / normally closed
SP1
-40 ... +124.5
-40 ... +256
rP1 in Schritten von
0.5
1