led2work TUBELED_40 II Betriebsanleitung Seite 13

TUBELED_40 II
5 | Connection
Suitable connection material, cables and accessories can be found in the accessory
range of LED2WORK.
The LED light can be controlled using 3 different operating modes, which can be select-
ed as desired. The wire cross sections of the connecting cables used are the
PIN assignment of the M12 connector is as follows:
4
1
Schematic drawing of M12 plug
Mode 1
PIN 1 = 24V DC
PIN 2 = not used
PIN 3 = GND
PIN 4 = not used
PIN 5 = not used
The luminaire can only be switched ON and OFF by switching the supply
voltage at PIN 1.
Mode 2
PIN 1 = not used
PIN 2 = not used
PIN 3 = GND
PIN 4 = 24V DC
PIN 5 = not used
The luminaire can only be switched ON and OFF by switching the supply
voltage at PIN 4.
3
Possible variants of the M12 connector
5
2
PIN 1
Light
PIN 4
Light
Voltage at PIN
t
Action luminaire
t
Voltage at PIN
t
Action luminaire
t
| 13