Safety Information; Assembly / Mounting - led2work TUBELED_40 II Betriebsanleitung

Installation of electrical equipment may only be carried out by quali-
fied electricians.
Follow the five safety rules according to DIN VDE 1005.
Failure to do so may result in damage to the LED luminaire, as well
as fire or other hazards.
Danger of electric shock! Disconnect before working on the
device or load. Ensure to disconnect all circuit breakers that supply
dangerous voltages to the device or load, when doing so. Even
when the device is switched off, the load is not galvanically isolated
from the mains.
Only use the device if it is completely free of faults, and with safety
and awareness in mind.
If warnings or symbols are attached to the luminaire, they must not
be removed.

4 | Assembly / Mounting

Check the LED luminaire before installation to ensure it is complete and shows no
signs of damage. Do not use the luminaire or accessories if they are damaged, as
there is a risk of injury.
The LED luminaire comes fully assembled. The luminaire is attached via optional
mounting hardware:
TUBELED_40 II Luminaire holder, aluminium, 1 pair
TUBELED_40 II Mounting bracket, V2A, 1 pair
TUBELED_40 II Mounting bracket, V2A, 1 pair, incl. magnet
If attached using the mounting brackets, the LED luminaire is continuously adjustable
by 111° in its rotation axis.
When mounting the luminaire, make sure that the luminaire is
fastened securely and stably. If the luminaire falls down, its weight
poses a risk of injury!
12 | BA TUBELED_40 II . BA 11/2018

3 | Safety information

Item no.
210200-06
210200-11
210200-12