Operation - Rollei Studioblitz 400 Anleitung

Wireless control
20
Regulating the flash power
Press the + (6) and – (7) buttons in order to adjust the flash output .
The flash power can be set from 1 .0 to 7 .0 .
The minimum output is 1 .0 and the maximum is 7 .0 . For changes of 0 .1 f-stops in
each case, press the + (6) or – (7) button once .
For large adjustments hold down the + (6) or – (7) button for two seconds and the
flash power will change by 1 f stop .

Operation

Changing the micro fuse
WARNING: Risk of electric shock and fire due to the short-circuit of a micro
fuse, which doesn't meet the prescribed specifications and provides no
protection for overload and securing the device . Only use a micro fuse, which
meets the prescribed specifications, for this device . See Technical Information .
Please note: There is a spare fuse in the fuse holder .
1 . Switch off the device .
2 . Disconnect the power plug to interrupt the power supply .
3 . Open the fuse holder: with a small screwdriver, carefully lift the fuse holder
somewhat out of the module .
4 . Pull the fuse holder completely out of the module with your hand .
5 . Pull the old micro fuse out of the mounting bracket .
6 . Insert the new micro fuse into a central position on the mounting bracket .
7 . Push the fuse holder carefully into the module to the stop until it clearly clicks in .
ENGLISH