Operation - Rollei Studio 300 Anleitung

Operation

1) General notes on commissioning
– Please check the scope of delivery for completeness:
1 x Rollei Studio 300 / 500 studio flash, 1 x protective cap, 1 x mains cable 4 .5 m,
1 x instruction manual .
– Before using the flash for the first time, please read the operating instructions
completely and observe all warnings and safety instructions .
– Mount the flash on a lamp tripod, lock it in place using the lamp tripod lock [3] .
Adjust the tilt of the flash with the tilt lock [2] .
– Remove the protective cap from the flash tube . To do this, pull the bayonet
release button [b] to the rear, turn the protective cap to the left and remove it to
the front .
– Put on the desired light shaper / flash umbrella . The flash unit is equipped with
an umbrella holder for reflector/translucent umbrellas and the Bowens S-type
bayonet [a] for the use of a wide variety of light shapers (softboxes, reflectors,
beauty dishes, etc .) .
a) Bowens S-type bayonet (3x)
b) Bayonet release
c) Bayonet pins (3x on the light shaper)
a
c
25
b