Wireless Control; Signal Tones; Modelling Light - Rollei Studioblitz 400 Anleitung

Wireless control

18
Press the "Wireless Control" button (13) to activate different radio transmitters,
navigate with "+" (6) and "–" (7) buttons to navigate through the different settings .
*Canon, Nikon, Sony und Fuji are registered trademarks, Canon, Nikon, Sony or Fuji products are trademarks or
registered trademarks of Canon, Nikon, Sony or Fuji Corporations .
Wireless control:
C: Wireless Canon* control (the flash unit can be controlled by means
of a Canon* transmitter, which is available as an option)
N: Wireless Nikon* control (the flash unit can be controlled by means
of a Nikon* transmitter, which is available as an option)
S: Wireless Sony* control (the flash unit can be controlled by means
of a Sony* transmitter, which is available as an option)
F: Wireless Fuji* control (the flash unit can be controlled by means of
a Fuji* transmitter, which is available as an option)
6: In this mode, cameras from up to 7 manufacturers can be
controlled by means of the U7 transmitter, which is available as
an option)
O: Wireless control is disabled .

Signal tones

Press the signal tones button (9) for 3 seconds in order to enable
tones . The tones can be enabled and disabled . If the function is
enabled, then the flash unit emits audio signals and the symbol is
shown on the display .

Modelling light

Press the modelling light button (9) once in order to enable the
modelling light . Here the brightness of the modelling light is emitted
in proportion to the adjusted flash output . Press the modelling light
button (9) again to reach the 100% mode . To disable the modelling
light, press the modelling light button (9) again .
ENGLISH