be cool FEED Gebrauchsanweisung Seite 13

GB
Assembly instructions
1
Assembling the backrest and booster
Join the backrest to the booster, fit the screw into the holes in the axle (fig.1).
2
Joining the booster-backrest set to the armrest
Insert the two pegs on the base into the corresponding holes on the left side of the left armrest
(fig. 3).
3
Insert the peg on the backrest into the corresponding threaded hole (fig. 4).
4
Use a screwdriver to tighten the plastic screws in the holes (fig. 5).
5
Insert the two chair joints into the corresponding holes (fig-6). Then, use the screws to fasten the
joints in the same way as in step 3 (fig. 7).
6
Assembling the table
Insert the tabletop and the table joint (B) into the holes in the left or right sides respectively (fig. 9
and 10) and tighten the screws securely.
Assembling the chair and the table
7
Fit the chair over the tabletop (fig. 11) until they are lined up and press the button to complete the
procedure (fig. 12).
8
Fitting the adjustable tray
Insert the holes on each side into the corresponding places (fig. 13). Press the adjuster button while
pulling the tray outwards until you hear it click (fig. 14 and 15). The tray can be set to 3 different
positions.
9
Removing the cover
Press the oval button in the centre of the harness and unfasten it (fig. 16).
10
Press the button on the side of the buckle and remove the belt (fig. 17).
11
Take the belt off through the holes and then remove the cover (fig. 18-21).
Fitting the caps on the legs
12
There are four different caps D1, D2, D3, D4.
Fit each cap in the correct position (fig. 22).
Position for use as a table and chair
13
Functioning instructions for the highchair
Placing the child in the seat.
1. Assemble the highchair correctly and then place the child in the seat.
2. Fasten the harness.
3. Adjust the restraint system as required.
4. Fit the adjustable tray.
IM 1808 FEED ins.indd 13
13
17/12/14 09:32