Maintenance - Fora Diamond Cuff BP Bedienungsanleitung

Diamond CUFF BP Owner's Manual
Reviewing Test Results
Your device stores the 200 most recent blood pressure test
results along with respective dates and times in the memory. To
recall the memory, you have to connect your Diamond CUFF BP
to your mobile device. Once connected, the measured data is
automatically imported to iFORA BP app.
Appendix

Maintenance

Changing Battery
When the battery is low, one of the following screen will appear:
the " " icon appears with display messages (q): This indicates
the device is functional and the result remains accurate, but it
is time to change the batteries.
the " " icon appears with E-b (r): This indicates the power is
not enough for a measurement. You must change the batteries
immediately.
To change the batteries, do the following:
1. Push down the battery compartment cover to open it.
2. Remove the old batteries and replace with four 1.5V AAA size
alkaline batteries.
3. Close the battery compartment cover.
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS.
CAUTION
Note:
When the " " icon appears on the screen (s), it indicates that you
need to synchronize with your mobile device in order to adjust the
date and time settings. In addition, this measurement will not be
stored in meter memory.
Replacing the batteries does not affect the test results stored in
memory. However, if you did not synchronize with your mobile
device after the battery replacement, the measured data will not be
stored in the memory.
Keep away these batteries from small children. If swallowed,
promptly seek medical assistance.
Batteries may leak chemicals if unused for a long time. Remove the
batteries if you are not going to use the device for an extended
period.
Properly dispose of the used batteries according to your local
environmental regulations.
Caring for Your Device
To clean the device exterior, wipe it with a cloth moistened
with tap water or a mild cleaning agent, then dry the device
with a soft dry cloth. Do NOT flush with water.
Do NOT use organic solvents to clean the device.
Do NOT wash or iron the pressure cuff.
Device Storage
Storage condition: -25°C to 70°C, within 10%~95% relative
humidity.
Always store or transport the device in its original storage case.
Avoid dropping and heavy impact.
Avoid direct sunlight and high humidity.
EN-5