Integrated Battery Pack; Error Codes; Servicing; Service Address - Herth+Buss SelectH2 mini Bedienungsanleitung

Operating Instruction

7.2 Servicing

EN
Generally, we
gas detector inspected annually by the
manufacturer's
specialist authorised by the manufacturer,
or an authorised service point.
In addition, we recommend having the
following preventative measures conducted
by the manufacturer's customer service
or the manufacturer-authorised specialist/
service point:
Annual inspection and factory calibration
of the gas detector

7.3 Service address

In the event of complaints, calibrations and
repairs outside of the warranty, please send
the devices to the following service address:
Herth+Buss Fahrzeugteile GmbH & Co. KG
Dieselstraße 2-4
63150 Heusenstamm
Tel: +49 (0) 6104 / 608-0
E-Mail: info@herthundbuss.com
Attention! Please enclose proof of
purchase and accessory parts.
www.herthundbuss.com
recommend having
customer service,

8. Error messages

8.1 Integrated battery pack

the
If the integrated battery pack is
a low on power, the battery symbol
ACCU
will appear on the display. The
device can still be used for a maximum of 15
minutes when in this operating condition.
After this, the word BATT will appear in the
display and the SelectH
itself off.

8.2 Error codes

During operation, the device checks the
plausibility of the sensor values. In addition,
the parameter memory is tested for data
validity each time the device is switched on.
If errors are detected, the relevant error code
is shown in the display.
Error messages
E 32 Gas sensor
contaminated
E 64 Gas sensor
error
E128 Parameter
memory error
All further error codes are the sum of several
of the individual errors listed above.
95980019
mini will switch
2
Operate the gas
detector for approx.
15 min. in clean
ambient air.
Repeat this procedure
as required.
Alternatively, turn
the device on and off
several times.
Return the device to
the manufacturer
Return the device to
the manufacturer
30