Introduction; Operation; Conventions; Safety Instructions - Herth+Buss SelectH2 mini Bedienungsanleitung

Operating Instruction

1. Introduction

EN

1.1 Operation

The SelectH mini is a multi-range gas detector
2
based on MOX gas sensors for hydrogen (H
The device detects H
few ppm to the lower explosion limit (LEL).
The SelectH mini gas detector described in
2
this manual is intended for use by qualified
and trained specialist staff in line with these
operating instructions.
These operating instructions will inform
users performing gas detection work about
the construction and function of the gas
detector, and is a guide for handling the
device and its components.
This device can be operated in the countries
of the European Union (EU). Outside the
EU, the national provisions of the respective
country apply.
These operating instructions describe the
state of the device at the time of publication.
Changes to the information and technical
configuration are reserved.
www.herthundbuss.com
concentrations from a
2

1.2 Conventions

Instructions that are carried out in a certain
). sequence are summarised in action units.
2
Safety instructions
warning/notice symbols and a signal word.
If necessary, the hazard is described. The
warning and notice symbols are explained
in the section "Safety instructions" .

2. Safety instructions

For your own safety, please read this chapter
in full before starting, in order to ensure safe
and fault-free use of the gas detector.
Please observe
instructions listed
instructions, as well as all messages and
instructions issued by the device.
No claims for warranty or liability can be
made for damages that arise due to incorrect
operation of the device, or through use of
non-original spare parts, wearing parts or
consumables. Damage to wearing parts is
also not covered by the warranty.
95980019
are identified with
and follow all safety
in these operating
20