Inhaltsverzeichnis
Werbung
STEP 08-2
CABLE ASSEMBLY
1. CONNECT THE CABLE WITH NO BALL (15)
TAKE ONE END OF THE CABLE TO ONE OF CHEST SUPPORT WITH SCREW M10*20
AND LOCK NUT (31) AS SHOWN. THEN THREAD THE OTHER END OF THE CABLE
OVER PULLEY NO.1, DOWN AND AROUND PULLEY NO.2 IN VERTICAL FLOATING
PULLEY BLOCK (AD), UP & OVER PULLEY NO.3, SECURE CABLE TO CHEST SUPPORT
USING SCREW M10*20 AND LOCK NUT (31) AS SHOWN.
2. CONNECT THE SHORT CABLE WITH ONE BALL (17)
START BY THREADING THE END OF THE CABLE WITHOUT THE BALL, OVER
PULLEY NO.12, OVER PULLEY NO.13, DOWN AND AROUND PULLEY NO.14 IN
PARALLEL FLOATING PULLEY BLOCK (AE), UP AND AROUND PULLEY NO.15, DOWN
WITH HOOK (12) AND IRON CHAIN (13) TO END OF CABLE, THEN ATTACH CABLE TO
SELECTOR SHAFT (8) WITH SCREW M10*35 AND LOCK NUT (30) AS SHOWN.
CONNECT THE LONG CABLE WITH ONE BALL (16)
3.
START BY THREADING THE END OF THE CABLE WITHOUT THE BALL, UNDER
PULLEY NO.4, UNDER PULLEY NO.5, UP AND AROUND PULLEY NO.6 IN VERTICAL
FLOATING PULLEY BLOCK (AD), DOWN AND UNDER PULLEY NO.7, UP AND AROUND
PULLEY NO.8 IN PARALLEL FLOATING PULLEY BLOCK (AE), DOWN AND UNDER
PULLEY NO.9, AROUND PULLEY NO.10, UP AND AROUND PULLEY NO.11, DOWN AND
ATTACH CABLE TO RIGHT SEAT VERTICAL SUPPORT (X) WITH HOOK (12) AS
SHOWN.
68
EN
Werbung
Inhaltsverzeichnis
