Observe The Following With Manual Addressing - Aventics LP04 Betriebsanleitung

34 AVENTICS | PROFIBUS DP | R402000616–BDL–001–AF
Assembling the LP04 PROFIBUS DP
Table 6: Byte X is the start address of the output section for this module in the pilot control.
Byte Regarding
X Valve
Coil
X + 1 Valve
Coil
X + 2 Valve
Coil
X + 3 Valve
Coil
Table 5: Addressing the bus coupler
Switch
1 SW2
2 SW1
3 Not used
The switches must not be changed during operation.
Changed switch positions will only become valid, after the
device has been turned off and restarted.
Bit
7 6 5
4 4 3
12 14 12
8 8 7
12 14 12
12 12 11
12 14 12
16 16 15
12 14 12
6.1 Observe the following with manual
addressing
The units and tens digits for the module addresses are switched
by the rotary switches (refer to Fig. 1).
Addresses from 2 to 99 are allowed.
O
Unscrew the caps of the rotary switches, tens and units.
O
Address the rotary switches by turning with a screwdriver.
– See Table 8 for LED functions.
Address
tens digits
unit digit
4 3 2
3 2 2
14 12 14
7 6 6
14 12 14
11 10 10
14 12 14
15 14 14
14 12 14
1 0
1 1
12 14
5 5
12 14
9 9
12 14
13 13
12 14