Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en
ENGLISH
It is possible that particles deposit inside the power
tool during operation. This impairs the cooling of the
power tool.
The power tool should be cleaned regularly, often
and thoroughly through all front and rear air vents
using a vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool from
the power source and wear protective glasses and
dust mask.
f
11. Accessories
Use only genuine Metabo accessories.
Use only accessories which fulfil the requirements
and specifications listed in these operating
instructions.
A Magazine screw attachment 6.31618
B Screwdriver bits (length: 25 mm)
Recommendation: only use screwdriver bits
with plug-in ends of this type:
C Battery chargers: ASC Ultra, ASC 15, ASC 30
and others.
D Battery packs 18 Volt: 5.2 Ah (6.25592); 4.0 Ah
(6.25591); 2.0 Ah (6.25596)
See www.metabo.com or the catalogue for a
complete range of accessories.
12. Repairs
Repairs to electrical tools must ONLY be carried out
by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.
13. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: never dispose of
power tools in your household waste! Used
power tools must be collected separately
and handed in for environmentally
compatible recycling in accordance with European
Directive 2002/96/EC on waste electrical and
electronic equipment and its implementation in
national legal systems.
Special notes regarding cordless machines:
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Before disposal, discharge the battery pack in the
power tool. Prevent the contacts from short-circu-
iting (e. g. by protecting them with adhesive tape).
12
14. Technical Specifications
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
U
=Voltage of battery pack
P
=Rated input power
1
P
=Power output
2
n
=No-load speed
0
n
=On-load speed
1
T
=Max. tightening torque
max.
H
=Machine toolholder
m
=Weight without mains cable
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
AC Power
Direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on the operating conditions, the
condition of the power tool or the accessories.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user e.g. organisational
measures based on the adjusted estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
=Vibration emission level (screwing without
h
impact)
K
=Uncertainty (vibration)
h
Typical A-effective perceived sound levels:
L
=Sound-pressure level
pA
L
=Acoustic power level
WA
K
, K
=Uncertainty
pA
WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
Werbung
Inhaltsverzeichnis
