Dometic WAECO CoolMatic HDC-150 Montage- Und Bedienungsanleitung Seite 35

_HDC150.book Seite 35 Donnerstag, 9. Dezember 2010 8:19 20
HDC-150
➤ Determine the required cross section of the cable in relation to the cable
length according to fig. c, page 9.
Key for fig. c, page 9
Coordinate axis
l
∅
NOTICE!
A
Make sure the polarity is correct.
➤ Before starting up the device for the first time, check whether the operat-
ing voltage and the battery voltage match (see type plate).
➤ Connect the refrigerator
– as directly as possible to the poles of the battery or
– to a plug socket which is fuse protected with at least 15 A (at 12 volts)
or 7.5 A (at 24 volts).
Connecting to a 230-volt mains supply
DANGER! Danger of fatal injury!
D
Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
If you are operating your cooling device on board a boat with a
mains connection of 230 volts from the land, you must install a
residual current circuit breaker between the 230 volt mains
supply and the cooling device.
Seek advice from a trained technician.
➤ Use the connection cable for the AC mains supply.
Meaning
Cable length
Cable cross section
Installing the refrigerator
Unit
m
mm²
35